Taking the Guesswork Out of CCNA Assignments: Proven Strategies and Examples

Greetings, networking enthusiasts! As your trusted CCNA Assignment Helper, we're dedicated to equipping you with the skills and knowledge needed to conquer your CCNA assignments with confidence. Today, we're diving into a couple of challenging CCNA questions along with detailed solutions, completed by our expert. Let's delve into the world of networking and unravel these complexities together.

Question 1:

You are tasked with configuring a basic VLAN setup on a Cisco switch. The network consists of two departments: Sales and Marketing. Each department requires its own VLAN. Configure VLAN 10 for Sales and VLAN 20 for Marketing. Ensure that VLAN 10 has ports Fa0/1 to Fa0/5 assigned to it, while VLAN 20 has ports Fa0/6 to Fa0/10 assigned to it. Additionally, set the switch's IP address to 192.168.1.1 with a subnet mask of 255.255.255.0.

Solution:

To configure VLANs on a Cisco switch, we'll utilize the following commands:

Switch> enable
Switch# configure terminal
Switch(config)# vlan 10
Switch(config-vlan)# name Sales
Switch(config-vlan)# exit
Switch(config)# vlan 20
Switch(config-vlan)# name Marketing
Switch(config-vlan)# exit
Switch(config)# interface range Fa0/1 - 5
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# exit
Switch(config)# interface range Fa0/6 - 10
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 20
Switch(config-if-range)# exit
Switch(config)# interface Vlan1
Switch(config-if)# ip address 192.168.1.1 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# exit
Switch(config)# end
Switch# copy running-config startup-config

Question 2:

You are troubleshooting a network connectivity issue and suspect that there might be a problem with the Spanning Tree Protocol (STP) configuration. How would you verify if STP is functioning correctly on a Cisco switch?

Solution:

To verify the Spanning Tree Protocol (STP) configuration on a Cisco switch, follow these steps:

1. Check STP Status: Enter privileged EXEC mode on the switch by typing `enable`. Then, use the command `show spanning-tree` to view the STP status. Look for the bridge ID, root ID, and port status to ensure proper functioning.

2. Check Root Bridge: Verify that the switch with the lowest Bridge ID is elected as the Root Bridge. You can check this by examining the output of the `show spanning-tree` command.

3. Check Port Roles: Ensure that each port on the switch has the correct STP role assigned. Ports designated as root ports or designated ports should forward traffic, while blocked ports should not.

4. Check Port States: Confirm that the port states are as expected. Designated ports and root ports should be in the forwarding state, while blocked ports should be in the blocking state.

By systematically checking these parameters, you can determine if STP is functioning correctly on your Cisco switch and diagnose any potential issues affecting network connectivity.

These master-level CCNA questions and solutions are designed to deepen your understanding of networking concepts and strengthen your problem-solving skills. Remember, practice makes perfect, so keep honing your skills and never stop exploring the vast world of computer networking.

Stay tuned for more expert insights and sample assignments from your dedicated CCNA Assignment Helper at https://www.computernetworkass....ignmenthelp.com/ccna Until next time, happy networking!

#computernetworkassignmenthelp, #computerassignmenthelp, #assignmenthelp,
#education, #study, #university